arduino examples

voltage_check/voltage_check.ino

@@ -0,0 +1,39 @@
+int result = 0;
+
+void setup(){
+   Serial.begin(9600);
+
+}
+
+long readVcc() {
+  // Read 1.1V reference against AVcc
+  // set the reference to Vcc and the measurement to the internal 1.1V reference
+  #if defined(__AVR_ATmega32U4__) || defined(__AVR_ATmega1280__) || defined(__AVR_ATmega2560__)
+    ADMUX = _BV(REFS0) | _BV(MUX4) | _BV(MUX3) | _BV(MUX2) | _BV(MUX1);
+  #elif defined (__AVR_ATtiny24__) || defined(__AVR_ATtiny44__) || defined(__AVR_ATtiny84__)
+    ADMUX = _BV(MUX5) | _BV(MUX0);
+  #elif defined (__AVR_ATtiny25__) || defined(__AVR_ATtiny45__) || defined(__AVR_ATtiny85__)
+    ADMUX = _BV(MUX3) | _BV(MUX2);
+  #else
+    ADMUX = _BV(REFS0) | _BV(MUX3) | _BV(MUX2) | _BV(MUX1);
+  #endif  
+
+  delay(2); // Wait for Vref to settle
+  ADCSRA |= _BV(ADSC); // Start conversion
+  while (bit_is_set(ADCSRA,ADSC)); // measuring
+
+  uint8_t low  = ADCL; // must read ADCL first - it then locks ADCH  
+  uint8_t high = ADCH; // unlocks both
+
+  long result = (high<<8) | low;
+
+  result = 1125300L / result; // Calculate Vcc (in mV); 1125300 = 1.1*1023*1000
+  return result; // Vcc in millivolts
+}
+
+void loop(){
+  result = readVcc();
+  Serial.println(result);
+  delay(1000);
+  
+}